Precor 9.33 Owner's Manual page 14

Diagram 8
Diagram 9
page 14
Secure the display
1
console.
CSAFE receptacle
Cable receptacle
Display console
¾
-inch screws (C)
with washers (D)
Tighten the screws,
but leave room for
adjustments.
b. Align the display console with the upright support mounts. Insert two ¾-inch
screws (C) with washers (D) and finger tighten. Do the same for the opposite
upright support. Do not securely tighten the screws until after the handrails
have been attached.
c. Attach the cable connector by sliding it into its receptacle underneath the
console. A definite "click" is heard when the cable is properly attached. Refer
to Diagram 8, #2. If you do not hear and feel the connector "snap" into place,
reinsert it.
Important: Do not use the receptacle covered by the plastic plug. This
CSAFE receptacle is for a separate and future purpose.
d. So that the cable does not hang below the console, slide it into the clip
found underneath the console. Refer to Diagram 8, #3.
Important: With the handrails attached, the width of the treadmill is 33½
inches (85 cm). It will not fit through a standard 32-inch doorway.
Raise the incline.
Quick Start key
Side rail
Incline lift
10. Prepare the unit for handrail installation. Diagrams 9 and 10. For an easier
installation, raise the incline to its maximum height by taking the following steps:
a. Plug the treadmill into a power outlet and turn the unit ON.
b. Stand to the side of the treadmill and press Quick Start (see inset). If
necessary, enter the password: INCLINE
three seconds, the running belt begins moving.
c. Press the INCLINE
d. Once the ramp stops moving and the display indicates 15 percent, press the
STOP (red button) and turn the unit OFF.
, SPEED
key until the display shows an incline of 15 percent.
2
3
, SPEED . After