Using The Remote Control - Yamaha RX-V1400 Owner's Manual

_ @0(ERX-VI400U EN.book Page 20 Thursday, July 10, 20(13
12:17 AM
• Connecting to an external amplifier
If you want to increase the power output to the speakers,
or want Io use another amplifier, connect an extex_nal
amplifier Io the PRE OUT jacks as follows.
• When audio pin plugs are connected to the PRE OUT jacks fk_r
output to an external amplifier, it is not necessary to use the
corresponding SPEAKERS terminals. Set the volume of the
amplifier connected to this unit to the maximum.
• The signal output through the FRONT PRE OUT and CENTER
PRE OUT jacks are affected by the TONE CONTROL settings.
• Signals will only be output fi'om the FRONT PRE OUT jacks
when SPEAKER A is turned off with ZONE B selected for SP
B SET (see page 57).
_ooo, 1
5"-- _°°°'3
_ooo,4
+
1 FRONT PREOUTjacks
Front channelline outputjacks.
2 SURROUND PREOUTjacks
Surround channelline outputjacks.
3 CENTER PRE OUT jack
Cenler channel line output jack.
4 SURROUND BACK / PRESENCE PRE OUT
jacks
Surround back or presence channel line output jacks.
5 SUBWOOFER PRE OUT jack
Connect a subwoofer with buill-in amplifier, such as the
YAMAHA Active Servo Processing Subwoofer Syslem,
to this jack.
+
• Each PRE OUT jack outputs the same channel signal as the
corresponding speaker terminals. However, when both surround
back and presence speakers are connected to this unit, the
channel of the signals output fi'om SURROUND BACK /
PRESENCE PRE OUT jacks may not corresp_)nd _o the
location of the speakers connected through SURROUND
BACK / PRESENCE PRE OUT jacks.
• Adjust the volume level ol _ " t he subwoof_r with the control on
the subwoof?r. It is also possible to adjust the volume level by
using the remote control of this unit (see "Manually adjusting
speaker levels" on page 45.).
• Some signals may not he output fi'om the SUBWOOFER jack
depending on the SPEAKER SET (see page 49) and LFE
LEVEL (see page 51) settings.
2O