Yamaha RX-V1400 Owner's Manual page 66

_ @00 RX-VI40(IU EN.book Page 62 Thursday, July lU, 20(13
iM,_lrll#jl,_OllTjlf_iojl_g_,Wlilj_l _ •
12:17 AM
5 Press and hold the button you want to
program on the other remote control until
"OK" appears in the display window,
BDD °
[ ]
[1888
[3[388
88
nl,:'!]iii;
+
• "NG" appears in the display window if programming was
unsuccessful. In this case, start over from step 5.
• This remote control can learn approximately 120 tunctions.
However depending on the signals learned, "FULL" may
appear in the display beti_re you program 120 _;anctions. In this
case, clear unnecessary programmed bmctions m make room
_\)r further learning.
6 Repeat steps 4 and 5 to program additional
functions.
7 Press LEARN again to exit from the learning
mode.
,-,.-- Dt! D
You can change the name that appears in the display
window on the remote control if you want Io use the
different name lhan the faclory preset. This is useful when
you have set the input selector to control a different
component.
Press an input selector button to select the
source component you want to rename.
The selecled component name appears in the display
window.
© o © "-"" Di.,iB
©oo¢? '
2 Press RE-NAME using a
ballpoint pen or similar
object.
3
Press/x
/ v to select
and enter a character.
Pressing v changes the character as follows:
A 1o Z, a Io z, 0 1o 9, space, -(hyphen), and/(slash),
(Pressing/x changes the characlei_s in reverse order.)
+
• Learning may not be possible in the fk)llowing cases:
-- When the batteries in the remote control fbr this unit or other
components are weak.
-- When the distance between the two remote controls is too
great or too small.
-- When the remote control infrared windows are not facing at
the appropriate angle.
-- When the remote control is exposed to direct sunlight.
-- When the _hnction _o be programmed is continuous or
/incon_n)oIl.
• "ERROR" appears in the display window if you press more than
one button at the same time.
4
Press < / > to move the cursor to the next
position.
5
If you want to continue setting up names _\)r other
components, press TV MUTE/SELECT and repeat steps 1,
3 and4.
Press RE-NAME again to exit from the
renaming mode.
¢
62