Yamaha RX-V1400 Owner's Manual page 82

_ @00N RX-VI40(IU EN.book Page 78 Thursday, July 10, 20(13
12:17 AM
[Igl$111=tl_"_glelSJll_*$
+
Problem
The sound suddenly
goes off.
Only the speaker on
one side can be
heard.
Only the center
speaker outputs
substantial sound.
No sound from the
effect speakers.
No sound from the
center speaker.
No sound from the
surround speakers.
No sound from the
surround back
speakers.
No sound from the
subwoofer,
Referto
Cause Remedy
page
The protection circuit has been activated
because of a short circuit, etc.
Check that the impedance selector setting is correct. 23
Check the speaker wires are not touching each other ....
and then turn this unit back on.
Tile sleep tfiner has turned the unit off. Turn on the power, and play the source again.
The sound is muted. Press MUTE to cancel a mute.
31
Incorrect cable connections.
Connect the cables properly. If the problem persists,
the cables may be dethctive.
12
Incorrect balance settings in the SET
MENU.
When playing a monaural source with a
CINEMA DSP program, the source signal
is directed to the center channel, and the
front and SmTOund speakers output effect
sounds.
Adjust the SP LEVEL settings.
Tile sound field programs are turned off. Press STRAIGHT/EFFECT to turn them on.
50
33
A Dolby Surround, Dolby Digital or DTS
decoding DSP program is being used with
material not encoded with Dolby
Surround, Dolby Digital or DTS.
Select another sound field program.
32
The output level of the center speaker is Raise the level of the center speaker.
set to minimulla.
50
"CENTER SP" in the SET MENU is set Select the appropriate mode for your center speaker.
m NONE.
49
One of the Hi-Fi DSP programs (except
for 7cb Stereo) has been selected.
Select another sound field program.
32
The output level of the SmTOUnd speakers Raise the output level of the surround speakers.
is set to minimum.
50
"SURR. LR SP" in the SET MENU is set Select the appropriate speaker mode for the sun'ou nd
Io NONE. L/R speakers.
49
A monaural source is being played with Press STRAIGHT/EFFECT to turn on the sound
STRAIGHT/EFFECT set to STRAIGHT. fields. Then select another sound field program.
Presence speakers are s_U_2ted.
Select surround back speakers in PR/SBcb SELECT. 53
"SURR. LR SP" in the SET MENU is set
to NONE.
If the speaker mode tbr the surround L/R speakers is
set to NONE, the speaker mode fi)r the surround back
speaker is automatically set to NONE. Select the
appropriate speaker mode for the surround L/R
speaker mode.
49
"SURR B LIR SP" in the SET MENU is Select LRG or SML.
set to NONE.
49
"LFE/BASS OUT" in the SET MENU is Select SWFR or BOTH.
set to FRONT when a Dolby Digital or
DTS signal is being played.
50
"LFE/BASS OUT" in the SET MENU is
set to SWFR or FRONT when a 2-channel
source is being played.
The som'ce does not contain low bass
signals.
Select BOTH.
50
+
78