Remote Control Panel; Specifications - Yamaha R-N500 Service Manual

R-N500

■ REMOTE CONTROL PANEL

6
RAS9

■ SPECIFICATIONS

■ Audio Section
Minimum RMS Output Power (Power Amp. Section)
(20 Hz to 20 kHz, 0.04 % THD, 8 ohms / L/R drive)
......................................................................................80 W + 80 W
Dynamic Power Per Channel (IHF)
8 / 6 / 4 / 2 ohms .......................................... 105 / 125 / 150 / 178 W
Maximum Power Per Channel (1 kHz, 0.7 % THD, 4 ohms)
[G model]
................................................................................................ 105 W
IEC Power (1 kHz, 0.04 % THD, 8 ohms) [G model]
.................................................................................................. 84 W
Power Band Width (0.06 % THD, 40 W, 8 ohms / MAIN L/R drive)
.................................................................................10 Hz to 50 kHz
Damping Factor (1 kHz, 8 ohms / SPEAKER-A)
....................................................................................... 150 or more
Maximum Effective Output Power (JEITA)
(1 kHz, 10 % THD, 8 ohms) [R, L models]
................................................................................................ 115 W
Input Sensitivity/Input Impedance
PHONO (MM) .................................................... 3.5 mV / 47 k-ohms
CD etc. .............................................................. 200 mV / 47 k-ohms
Maximum Input Signal (1 kHz)
PHONO (MM) (0.003 % THD) ....................................60 mV or more
CD etc. (0.5 % THD) ....................................................2.2 V or more
Output Level/Output Impedance (1 kHz, 200 mV / CD etc. input)
REC OUT ......................................................... 200 mV / 1.0 k-ohms
SUBWOOFER OUT .............................................. 4.0 V / 1.2 k-ohms
Cut off frequency .................................................................. 90 Hz
Headphone jack (8 ohms load) ......................... 410 mV / 470 ohms
Frequency Response (CD etc.)
20 Hz to 20 kHz ................................................................ 0 ±0.5 dB
10 Hz to 100 kHz (PURE DIRECT ON) ............................. 0 ±1.0 dB
RIAA Equalization Deviation
PHONO (MM) ...................................................................... ±0.5 dB
Total Harmonic Distortion (20 Hz to 20 kHz)
PHONO (MM) to REC OUT (3 V) ..............................0.025 % or less
CD etc. to SP OUT (40 W/8 ohms) ...........................0.015 % or less
Signal to Noise Ratio (IHF-A Network)
PHONO (MM), Input shorted 5 mV ............................ 87 dB or more
CD etc. (PURE DIRECT ON), Input shorted 200 mV
.............................................................................. 100 dB or more
Residual Noise (IHF-A Network)
................................................................................................. 30 μV
Channel Separation (CD etc., input 5.1 k-ohms shorted)
1 kHz .......................................................................... 65 dB or more
10 kHz ........................................................................ 50 dB or more
Tone Control Characteristics
Bass
Boost/Cut (20 Hz) ............................................................... ±10 dB
Turnover frequency ............................................................. 350 Hz
Treble
Boost/Cut (20 kHz) ............................................................. ±10 dB
Turnover frequency ............................................................ 3.5 kHz
Continuous Loudness Control (Attenuation 1 kHz)
................................................................................................-30 dB