Yamaha RX-V1400 Owner's Manual page 65

_ _00 RX-VI400U EN.book Page 61
Thursday, July 10,2003 12:17 AM
Igllrl[olll_ltioJ_TIl:fOJII;;l_'-|llJ:l'l •I
5
Press LEARN again to exit from the setup
mode.
2
Place this remote control about 5 to 10 cm
apart from the other remote control on a flat
surface so that their infrared transmitters are
aimed at each other.
• The supplied remote control does not contain all possible
manufacturer codes for commercially available AV components
(including Yamaha AV components), ff operation is not
possible with any of the manufacturer codes, program the new
remote control function with the Learn feature (see below) or
use the remote control supplied with the component.
• If you have already programmed a remote control function _k_r a
button, the function by learning programming takes priority
over the setup manufactm'er code's function.
• "ERROR" appears in the display window when press any
buttons other than indicated in each step, or when you press
more than one button at once.
8[388
8 [J88
8[3[3[3
3
5 to 10 cm (2 to 4 inch)
Press LEARN using a ballpoint pen or similar
object.
Do not press and hold LEARN. If you hold it down
for more than three seconds, the remote enlens the
manufacturer code setting mode,
+
If you want to program functions not included in the basic
operations covered by the manufacturer code, or an
appropriale manufacturer code is not available, do the
following. You can program any of the buttons available in
the component control area (see page 59). The buttons can
be programmed independently for each component.
This remote control uansmits infi'ared rays. If the other remote
control also uses infi'ared rays, this remo_e control can learn most
of its functions. However, you may not be able to program some
special signals or extxemely long transmissions. (Refer to the
operation instructions for the other remote controh)
1
Press an input selector button to select a
source component.
_T M_AOE
©oo© o
4
Flashes alternately
Complete each of the f\)llowing steps in 30 seconds.
Otherwise, the learning mode will be automatically
canceled. In this case, press LEARN again.
Press the button at which you want to
program the new function.
"LEARN" is displayed.
@o o ,
[3888
88[3[3
88[J8
f
R!q.
+
¢
61