Lubrication; Front Wheel Bearings; Axle Spindles; Steering Shaft - Snapper LT120G30DB Safety Instructions & Operator's Manual

MAINTENANCE INSTRUCTIONS
The followinglubricationpoints shouldbe servicedafter
each 25 operating hours to insure optimum performance
of the Series D Lawn Tractor.
FRONT WHEEL BEARINGS
Lubricateeach front wheel bearing through the grease
fitting on wheel hub. Using general purposegrease in a
greasegun, addgrease untilgreasepurgesfrom bearing.
See Figure 23.
AXLE SPINDLE
LUB RICATION
FITTING
AXLE SPINDLES
Lubricateeach axlespindlewith 1 shot ofgeneral purpose
grease. See Figure 23.
NOTE:
The R.H. spindle fitting faces forward and the L,H. spindle
fitting faces to the rear.
FRONT WHEEL BEARING
LUBRICATION FITTING
FIGURE 23
CLUTCH/BRAKE
PIVOT LUBRICATION
RTTING
CLUTCH//BRAKE PIVOT
The clutch/brake pivot is located on the L.H. underside of
the tractor and is lubricated with one shot of general
purpose grease. See Figure 24.
STEERING SECTOR GEAR
Lubricatewith a lightcoat of 30 wt. motoroil. See Figure
25.
STEERING SHAFT
Lubricatesteeringshaft wear points with a light coatof 30
wt. motoroil.
FIGURE 24
FUEL TANK
STEERING
SECTOR
SECTOR
GEAR
j"
17
FIGURE 25