Sector Plates - Snapper LT120G30DB Safety Instructions & Operator's Manual

MAINTENANCE INSTRUCTIONS
Slidesectoroffof pinsand carefullylowerdeckontoangle
iron.
33" DECK SHOWN
Rotate. b lade(s) until blade tips are at each side of deck.
•Measuredistancefrom blade tip to flooron each side
of
LMEASURE FROM
deck.
BLADE TIPS
TO FLOOR
Bladetips shouldbe within 1/8"ofeach otherfor thedeck
to be consideredlevel. See Figure66.
If measurementdiffersmore than 1/8",adjustas follows:
Loosen frontliftarm pivotboltonfrontof right side rail.See
Figure67.
NOTE:
The 38" deck does not incorporatea pivotbolt.
PIVOT BOLT
LOOSEN
SHOULDER BOLT
_-_ ANGLE IRON
FIGURE 66
f
Looseneccentricshoulderbolt. See Figure67.
Turn eccentric"UP"or'DOWN" as requiredto leveldeck.
See Figure67.
Tighteneccentricshoulderbolt.
Tighten pivotbolt.
J
ECCENTRIC
AS REQUIRED
FIGURE 67
Place sector plates back onto rear lift arms and secure
withwashers and hairpins. SECTOR PLATES
Make certainsector plates are mountedin the same _---_,,, ,,_ _ _;¢__ ________
holeson each side forproper frontto rear level.
FRONT TO REAR LEVEL-SECTOR PLATES --_-- "_-_
LOWEST OE
Remove hairpinsand washers securingsectorplatesto
rear lift arms. See Figure 68.
_ ~
_DECI(-S'_ING _ -------_-SETTING
Move sectorplate as requiredto raise or lowerdeck. ___.-__ .)_1 --'_ I _11_1_
DECK
REMOVE'
HAIR PIN & WASHER
FIGURE 68
32