Service & Lubrication Information - Snapper SPLH141KW Safety Instructions & Operator's Manual

SECTION 4 - SERVICE & LUBRICATION INFORMATION
TRACTION
Lubricate each with 1-2 shots of
grease every 25 hours of operation.
INTERLOCK
SWITCHES
Inspectswitches _rease
ofoperation.
HYDRAULIC OIL
Use SAE 10W-30 Oil.
IN-LINE FUEL FILTER
(Not Illustrated)
LINKAGES Replace every 100
Before each mowing period, coat all wear .............................................
points, hinge points and sliding parts with
medium duty oil.
Change Oil Filter after first 5 hours of
operation. Change engine oil every 25
hours under normal conditions or daily
under extreme dusty conditions. Change
Filter every 50 hours of operation.
every 25 hours. Service PAPER
ELEMENT every 100 hours.
HYDRAULIC
Change Hydraulic Oil
after first 25 hours of operation.
Thereafter, change Hydraulic Oil
and Filter every 200 hours
(monthly).
MOTOR HUBS
Motor Hubs with Anti-Seize
Compound when replacing
Wheel Hubs.
REAR TIRES - Check tire
pressure before each mowing
period. Inflate to 12-15 psi.
'CUTTER SHAFT
F SPINDLES
Lubricate each with two
(2) SHOTS of bearing
grease daily.
CUTTER DECK
BELT(S)
Check for cracks or
wear.
DEFLECTOR
Lubricate hinge
points as required.
HYDRAULIC HOSES &
FITTINGS
Check daily for leaks, cracks,
MOWING DECK
At end of each mowing period,
remove grass and debris from
under mowing deck and above
rear SAFETY Shield.
\
FRONT TIRES
Check tire pressure before
each mowing period. Inflate to
25 PSI.
FRONT WHEEL BUSHINGS
& CASTER SHAFTS
Lubricate with bearing grease
weekly.
MOWER BLADES
Check for tightness every 25
hours of operation. Tighten
capscrews to 75 foot pounds.
FIGURE 4.1
16