Rear Panelterminals - Mitsubishi HS-U270 Owner's Manual

Chapter1: Gettingto KnowYourVCR
Rear PanelTerminals
z 5
2 3
Q
®
®
audio input and output terminals
These terminals are called audio inputs
and outputs. They enable sound to flow
into the VCR (through the audio input)
and out to the TV (through the audio
output.) You may not need to use these
terminals if you have an older TV.
video input and output terminals
These yellow terminals are for sending
(OUT) and receiving (IN) video signals.
You will only need to use these if you have
a monitor television, or for making copies
of tapes.
antenna terminals
• antenna in (ANTENNA IN)
Use this terminal to attach an external
antenna or cable. This "brings in" an
outside signal.
_"antenna out (ANTENNA OUT)
Use this terminal to attach the VCR to
your TV. This terminal "sends out" the
signal to your TV.
6)
converter box contl._ol terminal
(CONVERTER BOX CONTROL)
Use this terminal to connect a cable that
sends signals to a cable box or satellite
receiver. (The cable is available from your
Mitsubishi dealer, pa='t name, "IR EMIT-
TEn.")
Use this cable if:
• your cable box or satellite receiver
cannot receive a si_._nal from the Con-
verter Box Contro! Transmitter, or
• you would like to _lace your cable box
or ,satellite receive: away from the
VCR.
A/V Network input terminal
Use this terminal to connect the VCR to a
Mitsubishi TV that has Active A/V Net-
work 1;erminal or _¢ Network terminal.
10