Rear View - Mitsubishi HS-7496E Installation And Operation Manual

FEATURES AND FUNCTIONS

REAR VIEW

1
The VCR illustrations appearing in this manual
are of the HS-7496E(B).
N
• Ensure the power cord is not plugged into the mains outlet before connecting to any rear terminals.
1 AC power socket
This socket connects to the power cord. Insert the cord
firmly.
2 SET IN terminal
Input terminal for alarm recording. The alarm sensor is
connected here.
3 RST (RESET) IN terminal
Input terminal to stop alarm recording when "ALARM REC
DURATION" of the "RECORDING SET UP" menu is set
to "MAN1". The alarm reset switch is connected here.
This terminal can also be used to set the on-screen clock
when set to any mode other than "MAN1".
4 REC IN terminal
Input terminal to start/stop recording. Also, use this
terminal for series recording (P.15) or synchronous
recording (P.16).
5 GND (GROUND) terminal
When a lead connected to other terminals requires a
ground, connect the ground lead here.
6 ALM (ALARM) OUT terminal
Output terminal to indicate alarm recording to an external
alarm.
7 MODE OUT terminal
Output terminal to indicate the VCR's mode of operation
which can be selected by setting the "MODE OUT" on
the "REAR TERMINAL" menu.
4 6
2
9
3 5
7 8
SET RST REC GND ALM MODE CLK CALL
IN
OUT
ÉMIC IN OUT
AUDIO IN OUT
VIDEO
G F E D C
8 CLK (CLOCK) OUT terminal
Output terminal to control an external camera switcher.
9 CALL OUT terminal
Output terminal to indicate when tape has finished
recording or if there has been a problem during recording.
A RESET button
When pressed, the present time, alarm recording list, power
loss list and the number of tape use will be erased. While
the button is pressed, the power is cut off from the VCR. If
there is a tape in the VCR and the button is released, the
power indicator will light and the tape will fast forward for a
few seconds. The VCR will then switch off.
B REMOTE jack
Remote control is possible by connecting the optional
remote control unit (R-7100) here. Refer to page 29.
C VIDEO OUT connector
Output connector for video signal (BNC connector). If
the power switch is turned OFF, the signal from the VIDEO
IN connector is looped out to this connector.
D VIDEO IN connector
Input connector for video signal (BNC connector).
E AUDIO OUT connector
Audio output connector (RCA pin).
F AUDIO IN connector
Audio input connector (RCA pin).
G MIC IN jack
Input jack for a microphone with 600 ohms impedance.
5
A
RESET
REMOTE
B