Panasonic KX-VC300 User Manual page 20

Setting up KX-VC Series NAT Traversal Service
"Max Resolution": Use [
maximum display resolution of the main video
camera and sub video camera used during a video
conference call.
– "Full HD": Maximum resolution: 1920 ´ 1080i
(This mode switches the display resolution
according to the condition of the network.)
–
"HD" (default [for KX-VC300]): Maximum
resolution: 1280 ´ 720p
(This mode switches the display resolution
according to the condition of the network.)
–
"Auto" (default [for KX-VC600]): This mode
selects either "Full HD" or "HD" according to
the available bandwidth.
Note
•
Selecting "Auto" or "HD" is recommended.
•
If you are using the KX-VC300, "Auto" or
"Full HD" can only be selected after
purchasing an activation key card
(KX-VCS401) to enable sending images in
Full HD resolution.
•
When "Full HD" is selected, if the other
party has a low bandwidth, the display
resolution may be lower than when "HD" or
"Auto" is selected.
•
If the other party's unit is located outside
your country/area, the field frequency
between your units may be different. In this
case, the maximum resolution will be
"HD", even if you have specified "Full
HD".
•
When making a 3-party video conference
call, the main video camera will be
automatically set to "HD", even if you have
specified "Full HD".
•
When making a 4-party video conference
call, the main video camera and sub video
camera will be automatically set to "HD",
even if you have specified "Full HD".
•
When "Video Quality" is set to
"Sharpness", only "Full HD" and "Auto"
can be selected.
5.
Press [G].
•
A dialog box to confirm the saving of settings is
displayed.
6.
Use [ ][ ] to select "Yes" and press [Enter].
•
The select local site screen is displayed.
7.
Press [Home].
•
The Home screen is displayed.
20 NAT Traversal Service User's Guide
][ ] to select the
Selecting a Local Site
1.
Press [Menu].
•
The Menu screen is displayed.
2.
Use [ ][ ] to select "Select local site" and
press [Enter].
•
The select local site screen is displayed.
3.
Use [ ][ ] to select the local site for which "NAT
Traversal" is displayed in "Connection mode".
Note
•
For the currently selected local site,
" " is displayed in "Selected".
•
"Not Registered" is displayed for sites that
have not been registered.
4.
Press [G].
•
A dialog box to confirm the saving of settings is
displayed.
5.
Use [ ][ ] to select "Yes" and press [Enter].
•
The Home screen is displayed.
Note
•
When you select a local site, the name entered
in "Local site name" is displayed instead of the
unit name in the unit information.
•
If you cancel the local site selection, the
encryption key will return to the value specified
on the admin menu. Whether encryption is
enabled or disabled depends on the value
Document Version 2012-03