Panasonic KX-VC300 User Manual page 12

Setting up KX-VC Series NAT Traversal Service
11.
Use [ ][ ] to select the following items for input:
"IP Address": Use [
IP address information for this unit ("IP Address",
"Subnet mask", "Default Gateway") will be
obtained automatically from a DHCP server or will
be set manually.
–
"Auto" (default): Obtain the IP address
information automatically.
–
"Manual": Set the IP address information
manually.
"IP Address": Enter the IP address of the unit.
"Subnet mask": Enter the subnet mask.
"Default Gateway": Enter the IP address of the
default gateway.
Note
•
"IP Address", "Subnet mask", and
"Default Gateway" can be entered only if
"IP Address" is set to "Manual".
•
If the value for "IP Address", "Subnet
mask", or "Default Gateway" contains 1 or
2 digits numbers, enter these numbers as
they are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
"DNS Server": Use [
IP address information for the DNS servers
("Primary DNS Server", "Secondary DNS
Server") will be obtained automatically from a
DHCP server or will be set manually.
–
"Auto" (default): Obtain the IP address
information automatically.
–
"Manual": Set the IP address information
manually.
12 NAT Traversal Service User's Guide
][ ] to select whether the
][ ] to select whether the
Note
•
To select "Auto", "IP Address" must be
set to "Auto".
"Primary DNS Server": Enter the IP address of the
primary DNS server.
"Secondary DNS Server": Enter the IP address of
the secondary DNS server.
Note
•
"Primary DNS Server" and "Secondary
DNS Server" can be entered only if "DNS
Server" is set to "Manual".
•
If the value for "Primary DNS Server" or
"Secondary DNS Server" contains 1 or 2
digits numbers, enter these numbers as
they are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
12.
Press [G].
If "Auto" is set for "IP Address":
A dialog box to confirm the saving of settings and
system restart after saving is displayed. Proceed to
step 15.
If "Manual" is set for "IP Address":
A dialog box to confirm the saving of settings is
displayed.
13.
Select "Yes" using [
The port number setting screen for the router is
displayed. Confirm that "Auto" (default) is set for
"Port Number".
If "Auto" is not set, follow the next step to change
the setting.
1.
Use [ ][ ] to select "Port Number".
2.
Use [ ][ ] to select "Auto".
14.
Press [G].
•
A dialog box to confirm the saving of settings
and system restart after saving is displayed.
15.
Select "Yes" using [
•
The system will automatically restart to reflect
changes to system settings. After the unit
restarts, check that "NAT Traversal Mode" is
displayed in the upper right of the Home screen.
][ ], then press [Enter].
][ ], then press [Enter].
Document Version 2012-03