Registering The Registration Key To The Unit - Panasonic KX-VC300 User Manual

Registering the Registration
Key to the Unit
Note
•
Check that "NAT Traversal Mode" is displayed
in the upper right of the Home screen. If it is not
displayed, change the connection mode to
"NAT Traversal Mode" (Page 13).
1.
Perform steps 1–6 in "If the unit has been used
before".
•
The admin menu screen is displayed.
2.
Press [ ].
•
The second page is displayed.
3.
Use [ ][ ] to select "Enhancement" and press
[Enter].
•
The software enhancement screen is
displayed.
4.
Press [G].
•
The Registration Key input screen is displayed.
Document Version 2012-03
Setting up KX-VC Series NAT Traversal Service
5.
Enter the 16-digit Registration Key.
6.
Press [G].
•
A dialog box to confirm the saving of settings
and system restart after saving is displayed.
7.
Select "Yes" using [
•
The system will automatically restart to reflect
changes to system settings. After the unit
restarts, the Terminal ID is displayed in the
upper right of the Home screen.
Note
•
If the Registration Key you entered is
invalid, "Failed Registration Key code
authentication." is displayed. Recheck the
information of the Registration Key that was
issued (Page 10), then repeat the
procedure from step 5. If this message is
displayed even when you have correctly
input the Registration Key that was issued,
contact your dealer.
•
After the unit restarts, "Terminal ID not
assigned" may be displayed in the upper
right of the Home screen. It may take some
time until the Terminal ID is displayed. If the
Terminal ID is still not displayed after 5
minutes, try the following:
a.
Check that the LAN cable is correctly
connected to the unit, and then restart
the unit.
b.
Connect the router to a computer, and
then check whether the computer can
connect to the Internet. If it cannot,
check whether the router's Internet
connection settings are configured
properly.
NAT Traversal Service User's Guide
][ ], then press [Enter].
15