Id Registration - Panasonic Attune WX-C3010 Installation Instructions Manual

4.2.4 ID Registration

• To talk with the headsets (Order Taker and All-in-One Headset), ID registration is required.
• For ID registration, set the center module in ID registration mode and make operation of ID registration by means of a
follower unit.
1. Press the ID Registration button of the center module for 2
seconds or more. The system is changed to the ID
Registration mode.
2. While holding down the T1 and T2 buttons simultaneously, hold down the power button to turn on the Order Taker. The
Order Taker enters the ID Registration setting mode where the indicators and buttons have different functions than in
normal operation. You will hear "ID Registration Mode" and the power indicator will blink yellow.
3. Press the T1 button and the headset will search for the center module. You can hear "Connecting center module A" and
the lane indicator will blink yellow. * Press the T2 button (at double-drive-thru), for other center modules. You can hear
"Connecting center module B" and the lane indicator will blink green. When the ID Registration succeeds, you will hear
"Registration complete" and the headset number, and the power indicator stops blinking and stays on.
4. When IDs are registered on all headsets, press the ID Registration button of the center module, ID registration mode is
completed. The power indicator of the headset will change from yellow to green.
Note:
• If ID registration fails, a warning sounds "beep" and then you will hear a voice prompt say "Failed". If registration fails,
the ID is not registered and the "Power" indicator blinks red. If this happens, turn off the power and try registering again.
• All-in-One Headset or Order Taker that can register in one center module is up to 30. If you register IDs exceeding 30,
the unused ID that has been registered is automatically deleted in chronological order.
Order Taker Unit
(WX-T3020)
All in One Headset
(WX-H3050)