Effect Types And Parameters - Zoom B3 Operation Manual

Effect Types and Parameters

Effect number Parameter
Effect type
This dynamic delay adjusts the volume of the effect sound
088 DynaDelay
according to the input signal level.
Page01
Page02
Effect screen
Effect Types and Parameters
001 OptComp This compressor is in the style of an APHEX Punch Factory.
Page01
002 D Comp This compressor in the style of the MXR Dyna Comp.
Page01
Page02
003 M Comp This compressor provides a more natural sound.
Page01
Page02
004 DualComp This is a compressor which allows separate settings for the low frequency and high frequency range.
Page01
Page02
005 160 Comp This compressor is in the style of the dbx 160A.
Page01
Page02
Parameter range
Knob1
Time 1–2000
Sets the delay time.
F .B 0–100
Adjusts the feedback amount.
Tempo synchronization possible icon
Parameter explanation
Knob1
Drive 0–100 P Tone
Adjusts the depth of the compression. Adjusts the tone.
Knob1
Sense 0–10
Adjusts the compressor sensitivity.
ATTCK Slow, Fast
Sets compressor attack speed to
Fast or Slow.
Knob1
THRSH 0–50 P Ratio
Sets the level that activates the
compressor.
ATTCK 1–10
Adjusts the compressor attack rate.
Knob1
Hi 0–50
Adjusts the compression depth in
the high frequency range.
Level 0–150
Adjusts the output level.
Knob1
THRSH -60–0
Adjusts the threshold that determines
when the effect is activated.
Knee Hard, Soft
Sets the type of knee.
Effect explanation
Knob2
Sense -10–-1, 1–10
Adjusts the effect sensitivity.
Level 0–150
Adjusts the output level.
Knob2
0–100
Knob2
Tone 0–10
Adjusts the tone.
Knob2
1–10
Adjusts the compression ratio.
Knob2
Lo 0–50
Adjusts the compression depth in
the low frequency range.
Tone 0–10
Adjusts the tonal quality of the sound.
Knob2
Ratio 1.0–10.0
Adjusts the compression ratio.
Level 0–150
P
Adjusts the output level.
Footswitch function
FS InputMute
Knob3
Mix 0–100 P
Adjusts the amount of effected sound
that is mixed with the original sound.
Pedal control possible icon
Knob3
Level 0–150
Adjusts the output level.
Knob3
Level 0–150 P
Adjusts the output level.
Knob3
Level 0–150
Adjusts the output level.
Knob3
Freq 300Hz– 1.5kHz P
Adjusts the crossover point between the
high frequency and low frequency range.
Knob3
Gain 0–20
Adjusts the gain after compression.
NEXT
33