Troubleshooting (Concerning The Saddle Stitch Finisher) - Olivetti d-Copia 3501 Operation Manual

SADDLE STITCH FINISHER

Troubleshooting (concerning the saddle stitch finisher)

Check the list below before calling for service.
Problem
Are any saddle stitch finisher covers open? Close all covers. (See page 3-14.)
The saddle stitch
finisher does not
Message indicating need to remove paper
operate.
from the stapler compiler displayed?
Message requesting check for the staple
unit displayed?
Stapling cannot be
Message
performed (including
displayed?
saddle stitch).
Different size paper included?
Stapled sets are not
stacked correctly or
Paper heavily curled?
some sheets in a set
are not stapled.
Punching does not
The punching function is not set for the
take place in the
correct positions.
correct positions.*
Message requesting check for punch
module displayed?
Different size paper included?
Cannot be punched.*
The paper is badly curled and is not
punched.
* When a punch module is installed
3-24
Check
requesting adding staples
Solution or cause
Remove all remaining paper from the stapler
compiler referring to step 4 on page 3-20.
Remove jammed staples. (See page 3-20.)
Replace the staple cartridge. (See page
3-19.) Check that a staple cartridge has been
installed. (See page 3-20.)
Stapling cannot be performed onto different
size paper.
Paper may be curled heavily depending on
the paper type and quality. Remove paper
from the paper tray or the bypass tray, turn it
upside down, and load it again.
Check the positions where punching is
possible.
Dispose of punch scraps. (See page 3-21.)
Stapling cannot be performed onto different
size paper.
Some types and qualities of paper may curl
badly when printed on. Remove the paper
from the tray or bypass tray, turn it around to
reverse the top and bottom, and then place it
back in the tray.