STORING, USING AND DELETING JOB PROGRAMS
Calling up a job program
Press the [#/P] key.
1
2
Touch the number key of the desired job
program.
JOB PROGRAMS
PRESS PROGRAM NUMBER.
RECALL
Deleting a stored job program
1
Press the [#/P] key.
Touch the [STORE/DELETE] key.
2
M NUMBER.
RECALL
STORE/DELETE
3
Select a storage register number of the
program to be deleted.
EXIT
STORE/DELETE
5-42
The
screen
automatically closes and
the job program is called
up. A number key that
does not have a job
program
cannot
be
selected.
If a number key for which
no job program has
been stored is selected,
the screen will change to
the screen of step 4 on
the previous page (for
storing a job program).
Set the number of copies if needed and
3
then press the [START] key.
4
Touch the [DELETE] key.
A JOB PROGRAM HAS BEEN ALREADY STORED
IN THIS LOCATION.
CANCEL
DELETE
STORE
RECALL
STORE/DELETE
[EXIT] key on the screen displayed in the screen of
step 3 to exit the job program mode.
NOTE
If overwriting of programmed copy settings has been
prohibited in the key operator programs, you will not
be able to clear a job program. (See page 15 of the
key operator's guide.)
Copying will begin using
the settings of the job
program.
The selected program is
deleted and you return
to the screen of step 3.
To return to the screen
of step 3 without deleting
the job program, touch
the [CANCEL] key. In
both cases, touch the