Troubleshooting (Concerning The Duplex Module) - Olivetti d-Copia 3501 Operation Manual

DUPLEX MODULE

Troubleshooting (concerning the duplex module)

Check the list below before calling for service.
Problem
Message indicating the paper type
cannot be used for two-sided printing
displayed?
Message indicating the paper size
The machine will not
cannot be used for two-sided printing
print duplex prints.
displayed?
Bypass tray extension not extended?
Printed images onto Does the number of sheets exceed the
paper from the limit?
bypass tray are
Paper guides properly set?
skewed.
Paper size and type set properly?
A paper misfeed
occurs in the bypass
Does the number of sheets exceed the
tray.
limit?
Paper guides properly set?
When printing on a
special size of The paper size setting is not set
paper, part of the correctly in the paper tray settings of the
printed image is custom settings.
missing.
3-4
Check
Special paper cannot be used for two-sided
printing. Use a paper type adequate for
two-sided printing. (See pages 2-4 and 3-2.)
Use a paper size adequate for two-sided
printing. (See pages 2-4 and 3-2.)
When using A3, B4, 11" x 17", 8-1/2" x 14" or
8-1/2 "x 13" paper, the bypass tray extension
must be extended.
Set paper within the allowable range.
Set the paper guides properly to the paper size.
When using non-standard size paper or special
paper, be sure to set the paper size and type.
(See pages 2-3 to 2-5.)
Set paper within the allowable range.
Set the paper guides properly to the paper size.
When using a special size of paper, set the
correct paper size as explained in "Setting the
paper type and paper size" on page 2-5. If the
paper size setting is not correct, part of the image
may be cut off or the image may not print.
Solution or cause