Olivetti d-Copia 3501 Operation Manual page 55

Problem
Is
recommended paper being used?
Is paper size or weight out of the
allowable range?
Printed paper is
wrinkled or the
image rubs off
easily.
Paper damp?
The contrast on the
touch panel is too Is LCD contrast properly adjusted?
high or too low.
The paper is loaded in the tray with the
Printing takes place print side face down*.
on the wrong side of * Face up if the paper type is "PRE-
the paper. PRINTED",
"LETTER HEAD".
Marks appear at
regular intervals on Paper with punch holes is being used.
printed pages.
Check
paper other than Olivetti-
"PRE-PUNCHED"
Solution or cause
Use Olivetti-recommended paper. (Page 2-16)
Use paper in the allowable range.
Be sure to store paper in the wrapper in a dry
location and do not store paper in a location that is
humid
at a high temperature or an extremely low
temperature
exposed to direct sunlight
dusty.
Adjust the screen contrast using "DISPLAY
CONTRAST" in "Default settings" of the custom
settings. (Page 2-14)
Load paper in the tray with the print side face up.
However, if the paper type is "PRE-PRINTED",
"PRE-PUNCHED" or "LETTER HEAD", load the
paper with the print side face down*.
* If the two-sided function has been prohibited
or
using "DISABLING OF DUPLEX" in the key
operator programs (page 11 of the Key
operator's guide), load the paper face up.
If the original image overlaps the punch holes,
marks will appear at the position of the holes on
the back of the paper after one-sided printing, or
on the front and back of the paper after two-
sided printing. Make sure that the original image
does not overlap the punch holes.
TROUBLESHOOTING
2
2-25