HP Surestore Disk Array 12h - And FC60 Advanced User's Manual page 389

If the disk module you are installing has been removed from another Disk Array
Note
FC60, you should ensure that the module has a status of Unassigned. This is
done by unbinding the LUN the disk module was a part of in the original disk
array. See "Moving Disks from One Disk Array to Another" on page
1. Remove the replacement disk from its ESD bag, being careful to grasp the disk by its
handle (A in Figure
2. Pull the cam latch (B) away from the disk module.
3. Mark the slot number that the disk is being installed into on the Slot Location Map on
the top of the disk module. See
the correct slot.
Figure 95
Disk Slot Identification Label
Use both hands to hold the disk — one on the handle and the other on the
Note
carrier frame.
4. Slide the disk module into the slot with capacity label up (C in
96).
Figure 95. This facilitates reinstalling the disk module in
Mark Slot
255.
Figure 96).
Disk Enclosure Modules
389