HP Surestore Disk Array 12h - And FC60 Advanced User's Manual page 290

•
RAIDlevel -
RAID level used for the LUN. Valid RAID levels are 0, 1, and 5.
requires firmware version HP08 or later. A RAID 0/1 LUN is created by selecting RAID 1
with more than two disks.
•
<options> - options giving you control over how the LUN is configured.
valid options and what they do.
After binding a LUN, you must execute the insf -e command to install special
Note
device files for the LUN. This makes the LUN usable by the operating system.
Table 38
Command Options for Binding a LUN
Option Description
-c capacity Specifies the capacity of the LUN. Capacity
can be specified in megabytes (M) or
gigabytes (G) by appending the appropriate
letter to the capacity value.
By default, the LUN will use the entire
capacity available from all the disks. It is
possible to specify a lower value for LUN
capacity, but this will result in unused disk
capacity. Any capacity not included in the
LUN will be inaccessible and is essentially
wasted capacity.
Managing the Disk Array Using Array Manager 60
290
RAID 0 support
Table 38
Default
If not specified, the LUN capacity
will equal the total available
capacity of the specified disks.
If a capacity value is specified but
no letter is appended, gigabytes will
be assumed.
lists