HP StoreOnce B6000 Series User Manual page 18

Working with the library list
The library list in the top half of the page provides up to 9 columns of details.
To sort the list according to a column, click on the column heading and select Sort Ascending
or Sort Descending.
To hide or show columns, click on any column heading, select Columns and uncheck or check
the required columns.
Users with an Admin login may also create libraries. Click Create.
Table 7 Summary library details
Parameter
Name
Replication Role
Status
Device Type
Cartridges
Port
User data stored
Size on disk
Service set
18 VTL (Virtual Tape Libraries)
Description
This is the name that is used to identify that device (library). It is often helpful to use a
name that identifies the host or backup job with which it is associated.
This is the role of the library, which may be non-replicating, replication source or
replication target
This is the status of the library, which may be online, offline, notstarted or failed to start.
This is the emulation type used by the backup software. It is selected when you create a
device.
This is the number of cartridges available on the device, which is determined by the
Emulation Type selected when the device was created. You can reduce the number of
slots in the Device Details tab for a library selected on this page, but this will only remove
the highest blank slots. Once it reaches a slot number that contains data, it will not allow
you to reduce the number further on this page, even if earlier slots are blank. You must
first use the Cartridges tab to make the slot blank.
This identifies the port to which the host is connected for backup and restore. The number
of ports available in the drop-down menu depends upon your network configuration.
This is the amount of user data stored on the library.
This is the actual size on disk (after deduplication).
The service set (or node) to which the library belongs.