Electronically Controlled Cameras - Nikon COOLPIX P90 User Manual

_"_Problem
Date imprint not
available,
Date not
appearing on
pictures even
when Date
imprint is
enabled,
Cause/Solution [_[]]
Date has not been set, 20, 138
Dates cannot be imprinted in the following situations,
When Museum, or Panorama assist is selected in scene
mode.
When Continuous or BSS is selected for Continuous
When any setting other than Off is selected for Auto
bracketing
When _ (blink proof) is selected
When sport continuous mode is selected
Movies
45, 47
118
121
55
56
81
139
154, 156
Camera settings Backup battery is exhausted; all settings were restored to
reset, their default values.
Reset file numbering cannot be applied when the
folder number reaches 999 and there are images in the
Reset file folder, Change the memory car{], or format the internal
memory/memory card.
numbering cannot Reset file numbering cannot be done if scene mode is 154,156
be done. set to Panorama assist or Voice recording, and if
Continuous is set to Intvl timer shooting when P, S,
A, M,U I
or U
2 shooting
modes
are
used,
Battery temperature is high. Turn off camera, and allow
Monitor turns off, battery to cool down before resuming use. After the lamp
and the power on blinks for three minutes, the camera will turn off 19
lamp blinks rapidly, automatically, but you can also press the power switch to
turn it off manually.
Electronically Controlled Cameras
In extremely rare instances, unusual characters mayappear in the monitor and the camera
may stop flsnctioning.
In most cases, this
phenomenon
is caused
by a strong
external
static charge. Turn the camera off, remove and replace the battery, then turn the camera
on again.In theeventofcontinued malflJnction, contactyourretailerorNikon
authorized
service
representative.
Note that
disconnecting
the power source as described above
may result in the loss
of any
data not recorded to internal memory or the memory caret at
the time the
problem
occurred. Data
already
recorded will not be affected.
2-
z
o
167