Panasonic Palmcoder PV-D407 Operating Instructions Manual page 9

1
POWER Lamp DC IN _ Connect VCR DC OUT on the
_ Con ector ACmAcdapto _ totDC 'eNDOcntheer
r_ Cable (supplied).
VCR ;cou' noecto, 2P,u ,n the , C,Oapt=.
* The POWER Lamp will tight.
Notes:
• AC Adaptor cannot be used to power the Pa_mcorder while charging the Battery.
• While not in use, unplug the AC Adaptor from the AC outlet. (When plugged into an AC outlet, the
AC Adaptor consumes 1.2W of electric power when not in use.)
DC IN
C°n nec_.._te r
Socket (1:
Car Battery Cord Cigarette
(optional) Lighter Plug
Connect a PV-C16 Car Battery Cord
(optional) to DC IN on the Pa[mcorder.
First, start your car engine, and then
insert the Car Battery Cord plug into
your cigarette lighter socket.
• A fuse is located in the lighter plug end of
the cord.
Should fuse replacement be necessary
use the exact current rating (in amps).
Notes:
• This cord can only be used in vehicles
equipped with DC 12V (negative ground)
batteries. Use only the specified car battery
cord, If you are not sure, check with your local
car/truck dealer,
• To avoid blowing the fuse, be sure to start your
car engine before inserting the cigarette lighter
plug of the Car Battery Cord into the lighter
socket.
• Because the car is running while your
Patmcorder is in operation, make sure
you're in a well ventilated area.
• Disconnect the cigarette lighter pIug when
your Palmcorder is not being used.
9