Panasonic Palmcoder PV-D407 Operating Instructions Manual page 19

• : •, t " • - • Before you begin...
To improve recording indoors or outdoors in • Connect the Palmcorder to a power source.
dim lighting conditions. • Set the POWER switch to CAMERA.
Set the LIGHT switch to AUTO.
The built-in light automatically turns on and
off depending on lighting conditions.
Or set the LIGHT switch to ON/OFF to
turn the light on and off manually.
_.1_ will appear in the EVF while the light is
turned on,
Caution:
This light becomes hot during operation.
Make sure nothing covers the Light during
operation.
Built-in Light Unit Bulb Housing
r
DANGER:
When replacing the bulb, use only lamp bulbs
(PART NO. VLLWO007) supplied by
Panasonic to reduce the risk of fire,
Use a cloth or tissue when handling the bulb
as finger oils will decrease the bulb life.
To prevent possible burn hazard, disconnect
the Built=in Light and allow the lamp to cool
before replacing.
_41 i III IIIII
Before you begin...
• Set the POWER switch to OFF.
Turn screw counterclockwise and
remove.
2(_ Slide the Built-in Light unit to the
right to unlock (_ and remove it.
Turn the Bulb Housing counterclock-
wise 1/4 of a turn and pull free from
the Built-in Light unit.
Using a clean cloth or tissue, replace
the bulb.
5(_) Replace the Bulb Housing by
turning it clockwise. _) Next, insert the
Built-in Light unit and slide it to the left
to lock it in place. (_ Finally, replace
the screw.
Note:
• Using the tight reduces battery operating time.
• If using the Built-in Light in a hot environment
for an extended period of time, be sure to
provide ventilation,
• Using the Built-in Lighl when the Patmcorder is
powered by a car battery may shorten bulb life.
• Be sure LIGHT switch is set to OFF when not
in use or before placing Palmcorder into an
optional carrying case.
19