Panasonic Palmcoder PV-D407 Operating Instructions Manual page 7

Charge the Battery Pack fully /,
before operation.
/'_!_
POWER _ _
/
I Plug in the AC Adaptor.
CHARGELamp 9 POWER Lamp lights.
,i_f Insert the Battery
Align the right side of the Battery with
the line on the AC Adaptor.
(_) Press the Battery down and slide it in
the direction of the arrow.
CHARGE Lamp lights. When charging is
done (about one and a half hours) the
lamp goes out.
Remove the Battery
Slide the Battery out and lift up.
Note:
After recharging the Battery Pack about 5 times,
use the BATTERY REFRESH feature as
explained on page 8.
• The useful operation time of the Battery will
gradually decrease after repeated use and
recharging, The Battery is no longer
serviceable il the operation time is very short,
even after a sufficient charge.
With a fully charged Battery Pack, you wil! have a maximum of about one and a half
hours of continuous use. (If the Built-in Light is used, battery operating t_,medecreases.)
the Battery
(_ Align the Battery with the top of the
mounting surface.
(_ Press it into place until it locks with a
click.
Remove the Battery
While sliding the BATTERY RELEASE
button, remove the Battery,
7