Panasonic Palmcoder PV-D407 Operating Instructions Manual page 35

Before you begin...
below,
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER
switch to VCR.
• Connect the Palmcorder to VCR as shown 1 Insert a pre-recorded tape
into the Palmcorder and a blank
tape with a recording tab into your
VCR.
Press PLAY on the Palmcorder and
when you find the starting point, press
STILL.
Source (Playing)
Palrncorder
Press PLAY and REC together on
your VCR and then immediately
press STILL/PAUSE.
REW PLAY FF REC
VCR Buttons
Audio/Video Out 3"1
TV
Press STILL on the Palmcorder
and press STILL/PAUSE on the
VCR to simultaneously start both
units.
(supplied)
Cable
Connecting Cable 5Press STOP on both units
(not supplied) when dubbing is complete.
To Audio In
Recording:
VCR
To Video
• Turn the TV ON and select its VCR
channel (CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
Note:
• Tapes recorded on other VCRs and used
for playback in the Palmcorder must be
recorded in SP or SLP mode.
• For technica! reasons, dubbing a tape may
reduce its quality.
CAUTION:
nauthorized exchanging and/or copying of)
pydghted recordings may be copyright |
dngement. ,........... }
35