Panasonic Palmcoder PV-D407 Operating Instructions Manual page 21

Whenever the Palmcorder is left in RECORD/PAUSE mode for 5 minutes, it wilt automati-
cally switch to Stand-by mode to conserve energy. Activating the Stand-by Quick
Release feature allows you to release the Stand-by mode and resume recording by
simply pressing the RECORD/PAUSE button. If this feature is not activated, it is neces-
sary to turn the Palmcorder OFF and back on to CAMERA to start recording again. The
default setting from the factory is set to thel_mode.
Before you begin...
o Connect the Pelmcorder to a power source.
Insert a cassette with record tab (see
Continue holding down the UP A
button before and after turning the
POWER switch to CAMERA until the
STAND-BY RELEASE menu screen is
displayed.
Press UP • or DOWN V to select
DISPLAY
IZ[o]_DL_[OdgAd
RECORDtPAUSE
S*TAND_ BY RELEASE
BY REGORD_AUSE KEY
S_=GT: PUSH ._ KEY
_ET : PUSH O_SPLAY KEY
You can resume recording from Stand-
by mode by pressing the RECORD/
PAUSE button.
You must set the POWER switch to
OFF, and then to CAMERA to release
the Stand*by mode.
Press DISPLAY to set your selection
and exit this screen.
21