Download Print this page

Panasonic Palmcoder PV-D407 Operating Instructions Manual page 4

Advertisement

t 5. Power Lines -- An outside antenna system should
not be located
in the vicinity of overhead
power
tines or other electric light or power circuits, or
where it can fall into such power Jines or circuits.
When installing an outside antenna
system,
extreme care should be taken to keep from
touching such power lines or circuits as contact
with them might be fatal
16. Overloading
-- Do not overload wall outlets and
extension cords as this can result in a risk Of fire or
electric shock.
17. Objects and Liquids -- Never push objects of any
kind into this video unit through openings as they
may touch dangerous voltage points or short out
parts that could result in e fire or electric shock.
Never spill liquid of any kind onto the video unit.
18. Servicing
-- Do not attempt to service this video
unit yourself as opening or removing covers may
expose you to dangerous
voltage or other hazards.
Refer all servicing to qualified
service personnel.
19. Damage Requiring Service -- Unplug this video
unit from the wall outlet and refer servicing
to
qualified
service personnel
under the following
conditions:
a, When the power-supply
cord or plug is
damaged.
b, If any liquid has been spilled onto, or objects
have fatten into the video unit.
c. if the video unit has been exposed
to rain or
water,
d. If the video unit does not operate normally by
Iollowing
the operating
instructions.
Adjust only
those controls that are covered by the operating
instructions, as an improper
adjustment
of other
controls may result in damage
and will often
require extensive work by a qualified
technician
to restore
the video unit to its normal operation,
e. If the video unit has been dropped or the cabinet
has been damaged,
f. When the video unit exhibits a distinct change in
pedormance
-- this indicates
a need for service
20. Replacement
Parts -- When replacement pads are
required,
be sure the service technician has used
replacement
parts specified by the manufacturer
or
have the same characteristics
as the original part.
Unauthorized
substitutions may result in fire,
electric shock or other hazards.
21. Safety Check--
Upon completion of any service or
repairs to this video unit, ask the service technician
to perform safety checks to determine
that the
video unit is in safe operating order_
USE & LOCATION
• TO AVOtD SHOCK
HAZARD
_,. Your Camcorder and power supply should not be exposed to rain or moisture.
Do not connect the power supply or operate your Camcorder
if it gets wet. Your Camcorder
has been designed
for outdoor use, however
it is not designed to sustain direct exposure to water, rain, sleet, snow, sand, dust, or a
direct splashing from a pool or even a cup of coffee. This action could permanently
damage
the internal parts of
your Camcorder.
DO not attempt to disassemble
this unit There are no user serviceable
parts inside. Unplug
your Camcorder
from the power supply before cleaning.
• DO NOT AIM YOUR CAMCORDER
AT THE SUN OR OTHER BRIGHT
OBJECTS
• DO NOT LEAVE THE PALMCORDER
WITH THE EVF AIMED DIRECTLY
AT THE SUN AS THIS MAY
CAUSE
DAMAGE
TO THE INTERNAL
PARTS
OF THE EVF
• DO NOT EXPOSE
YOUR CAMCORDER
TO EXTENDED
HIGH TEMPERATURE
... Such as, in direct sunlight,
inside a closed car, next to a heater, etc...
This action could permanently
damage
the internal parts of your
Camcorder.
• AVOID
SUDDEN
CHANGES
IN TEMPERATURE
... If the unit is suddenly moved from a cold place to a warm
place, moisture may form on the tape and inside the unit.
• DO NOT LEAVE YOUR CAMCORDER
OR THE POWER
SUPPLY
TURNED
ON WHEN NOT tN USE.
- STORAGE
OF YOUR CAMCORDER.,
Store and handle your Camcorder
in a manner that will not subject it to
unnecessary
mOvement (avoid shaJdng and striking). Your Cemcorder
contains a sensitive pick-up device which
could be damaged
by improper handling or storage.
CARE
- TO CLEAN
YOUR CAMCORDER
_. Do not use strong or abrasive
detergents when cleaning your Camcorder
body,
• TO PROTECT
THE LENS ... Do not touch the surface of the lens with your hand, Use a commercial camcorder
lens solution and lens paper when cleaning the lens. improper cleaning can scratch the lens coating.
• TO PROTECT
THE FINISH
OF YOUR CAMCORDER
o.. Before handling your Camcorder,
make sure your
hands and face are free from any chemical products, such as suntan lotion, as it may damage the finish.
4

Advertisement

loading