Panasonic Palmcoder PV-D407 Operating Instructions Manual page 8

IS_tt_4r_ _w t_ql*r=_'ltm=r,.,r, aa _ _K==
This feature completely discharges the Battery before recharging begins.
To maintain your Battery's operating capacity, use the refresh feature after about every five charges.
CHARGE
Lamp
1 Plug in the AC Adaptor.
• The POWER Lamp remains lit as long as the
AC Adaptor is plugged in.
Caution:
• Charge onlywith specifiedcharger,
• Bafterycan be charged within a temperature
range ol 32° F {0° C) and 104° F (40° C).
• Battery may be warm after chargingor just
after use, This is nnrmal.
• Do not use an insufficiently charged or worn-
out Battery.
Safety precautions:
• Do not get the Battery near, or dispose of in
fire.
• Do not directly connect (short circuit) the
positive (+) and negative (-) terminals.
• Never attempt to disassemble or reassemble
the Battery.
•---'--- U.S.A. CONSUMERS: ,,
ATTENTION:
8
Place the Battery into
the AC Adaptor.
Press the BATTERY REFRESH
button.
The CHARGE Lamp flashes until
discharge is complete and then stays llt
until the Battery is fully charged,
Remove the Battery.
• Should you accidentally press the BATTERY
REFRESH button, remove the Battery and
then re-insed it to begin charging.
• It takes about seven and a half hours when
both Battery Refresh and recharging are
performed.
To avoid damage to the Battery:
• Do not drop or jar Battery.
• Use Battery with specified units only.
• If Battery is used in extremely high tempera-
tures, a safety device will automatically
prevent operation.
To
prolong battery life:
• While not in use, remove Battery from the
Palmcorder and AC Adaptor and store in a
cool, dark, dry place.
• Keep Battery terminals clean.
The product you have purchased is powered by a nickel cadmium battery which is
recyclable. At the end of its useful life, under various state and local laws, it is illegal to
1
dispose of this battery into your municipal waste stream. PIease call 1-800-8-BATTERY/
for information on how to recy,cl.e this battery, , .....
)