Panasonic Palmcoder PV-D407 Operating Instructions Manual page 24

Your Palmcorder may be connected to a
TV to play back tapes or to view what you
are recording.
CTV withAUDIOiVIDEO IN Jacks. )
To Audio In
Audio/Video
Cable
(Supplied)
To Audio/Video Out
_TV without AUDIO/VIDEO IN Jacks. i_
Before you begin...
• Connect the Palmcorder to a power source.
Set the POWER switch to VCR for
tape playback,
Or, set to CAMERA to view what your
Palmccrder is recording.
Turn the TV ON and set it to L1NE
INPUT.
Check your TV operating instructions.
Note:
If your TV has no VIDEO or AUDIO IN jacks,
select CH 3 or 4 on yourTV to matchthe
CH 3/4 switch settingon the OPTIONAL
PV-RF16 RF Adaptor.Set the VCR/TV
selectoron the RF Adaptorto VCR for
playback.
Start playback or begin a recording.
To Audio/
Video Out
If you have connected the
Palmcorder to your TV using the
PV-RF16 RF Adaptor and want to
watch TV only:
T
Set the POWER switch to OFF on the
RF Adaptor Palmcorder.
(optional) _ VHF Antenna Then. set the VCR/TV Selector on the RF
JL Adaptor to TV.
_J_3q 300 ohm-75 ohm Now, turn the TV ON and select a
CH 3/4 Switch _II transformer channel.
_ j,,_ (not supplied)
_or F Connector _ _,
"_'i_3Yr'_'-'--'-" UHF Antenna
CATV System Installer
/ _ anal I_ This reminder is provided to call the CATV
VCR/FV lit . system instaIler's attention to Article 820-40
Selector _1 Back of TV of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides
VHF Connecting
VH;lC°nnecttng _ guidelines for proper grounding and, in
,_,_ul_ , .. _ I particular, specifies that the cable ground
l.not supp==ed)
(not supplied) I_ shall be connected to the grounding system
To VHF Antenna _ of the building, as close to the point of cable
Terminal _ entry as practtcal.
Y.L.._
24