Sharp FO-IS115N Operation Manual page 36

Setting up Network Scanning
Checking your IP address and the connection
To check the machine's IP address and verify that the machine is able to
communicate on the network, follow these steps.
1
Press
INFO
2
Press
•
If the machine has automatically received an IP address and is able to
communicate, [IP ADDRESS/DHCP: ON] will appear on the top line of the
display, followed by the IP address on the bottom line. To show the
machine's host name, press
•
If a static IP address has been entered in the machine and the machine is
able to communicate, [IP ADDRESS/DHCP: OFF] will appear on the top
line of the display, followed by the IP address on the bottom line. To show
the machine's host name, press
•
If the machine was unable to receive an IP address automatically, or if the
router locked up after the machine received an IP address,
[IP ADDRESS/DHCP: FAIL] / [192.168. 1 .201] will appear. "192.168. 1
.201" is an IP address that is assigned to the machine for diagnostic
purposes when connection fails (it cannot be used for regular
communication).
•
If [NOW CONNECTING / CHECK LATER] appears, press
This message will appear if a cable is not connected or the machine has
not yet established communication on the network. Make sure a cable is
correctly connected, wait briefly, and then repeat the procedure again.
32
, then until [NETWORK INFORMATION] appears.
.
.
.
STOP
to exit.