Epson PowerLite 1815p User Manual page 138

note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network On in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).
Managing Projectors
138
4. Highlight
On to receive email notifications, then
5. Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used:127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
6. Enter the SMTP server's port number. The default value is 25.
You can enter a numeric value from 1 to 65535.
7. Choose one of the
e-mail address where you want to receive a message when a
problem occurs. You can register up to three addresses. You can
enter up to 32 alphanumeric characters for the e-mail address.
8. Select problems or warnings to be notified about by mail.
(Numbers 1 through 3 in this section correspond to the e-mail
addresses you entered.)
9. When you're done making all necessary changes, select
select
Setup complete
want to save the changes. Press
When the selected problem or warning occurs, an e-mail message is
sent to the specified notification addresses. The subject line of the
e-mail is
EPSON Projector
information:
Line 1: The name of the projector where the problem has
■
occurred
Line 2: The IP address of the projector where the problem has
■
occurred
Line 3: Details of the problem
■
Destination Address
, and then select
Yes
to exit the menu system.
Menu
. The e-mail includes the following
press
Enter
fields, then enter the
,
Return
to confirm that you
.