Ricoh 4035e General Settings Manual page 68

User Tools (System Settings)
v Output: Printer (printer)
You can specify a tray to which documents are delivered.
Note
r Default: Internal Tray 1
r The output trays set on the printer driver have priority over the output tray
specified above.
r For details about output trays, see p.53 "Output: Copier (copier)".
v Prepare Stapling
When the booklet finisher is installed, perform a stapling test (five to seven
times) after replacing staples for saddle stitching, or removing jammed sta-
ples.
4
Note
r The display for this setting appears only when the booklet finisher is in-
stalled. See p.133 "Using "Prepare Stapling "in User Tools to initialize the
staple unit".
v <F/F4>Size Setting
Currently three types of F size are available; 8
8" 13"L. The ADF or exposure glass cover sensor cannot distinguish these
three types of originals. This function sets the F size from the ADF or expo-
sure glass cover sensor. Auto Paper Select or Auto Reduce/Enlarge can be
used for F size originals based on this setting.
Note
r Default: 8
Output tray settings
Limitation
r You cannot interrupt the current stapling job even if a stapling job is specified
by a different function.
r When the 1000-sheet finisher, 2 Tray finisher or booklet finisher is installed
and stapling or shift-sorting is specified for a job, the job will be delivered to
the finisher shift tray, finisher shift tray 1 or finisher shift tray 2 regardless of
the output tray specified.
54
1
/ " 13"L
2
1 1
/ " 13"L, 8 / " 13"L and
2 4