Refl Ective Panel Installation / Removal - Regency L965E-NG Owners & Installation Manual

REFLECTIVE PANEL INSTALLATION / REMOVAL:
•
Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth.
Use an ammonia based cleaner (ie. glass cleaner) to remove any fi ngerprints before applying heat to the unit.
Failure to do this will result in burn stain on panels which you will be unable to remove. Not protected by product warranty.
1. Install the Rear Porcelain Panel by placing it behind the burner. Use cau-
tion- do not scratch the panel.
Figure 74: Rear Porcelain Panel
2. Install the Left Refl ective Panel; it should be fl ush with the outer edge of
the fi rebox (see Figure 76).
With panel in position, slide panel clip in until it touches the panel, tighten
panel clip screws as shown in Figure 75.
Figure 75: Side Porcelain Panel and Panel
Clip
Regency L965E / HZ965E Gas Fireplace
Before installation, panels must be handled and cleaned as per instructions noted below:
Black Enamel Panels
3. Install the Top Panel by placing it on top of the Rear Panel and behind the
Left Panel (see Figure 77). Hold with one hand then place right side panel.
Figure 77: Upper Rear Porcelain Panel
4. Repeat same procedure in Step 2 to install Right Side Panel.
5. To remove panels, reverse steps.
INSTALLATION
Figure 76: Panel /Unit Alignment.
Figure 78: Final Install
45