Attaching Rip Fence - Craftsman 113.221620 Owner's Manual

2. Installthe SPREADER CLAMP.Placespreader
between spreaderclamp and bracket. Move
forwarduntilallthreeareinline.TIGHTEN WING
NUTS.
3. Lay a piece of straight flat wood againstthe
sawblade. I nsertfoldedpaperbetween spreader
andstrip of wood.
4. MAKE SURETHE HEX NUTS UNDERNEATH
ARELOOSE•
5. Lift the antikickbackpawlto clearthe woodand
hold the spreader t ightlyagainst t hewood.Make
sure the wood is against the saw blade.
TIGHTEN THEHEXNUTS.
This will alignthe spreader i n the middleof the
cut (KERF) m adeby sawblade.
THREE THICKNESSES
OF PAPER SPREADER
WING NOT CLAMP
PIECE OF
STRAIGHT WOOD
HOLD WOOD t
TIGHTLY AGAINST
BLADE
ANTIKICKBACK
PAWLS
HOLD SPREADER
TIGHTLY AGAINST WOOD
SPREADER BRACKET
ATTACHING RIP FENCE
Apply a coat of paste wax to the top surface and
front ledge of the saw table. This will allow the fence
to slide more easily•
1. Loosen fence lock knob by turning counter-
clockwise.
2, Attach fence head by placing head of fence over
front ledge in saw table.
RIP FENCE
FENCE LOCK
KNOB
19