Craftsman 113.221620 Owner's Manual page 17

INSTALLING BLADE GUARD
1. From among the loose parts, find the hardware as
shown.
SQUARE NUT
-_ (_/ SPREADER SUPPORTs..
TRUSS HEAD _ _ SPREADER BRACKET
SCREW _ _
5/8 IN. LONG "-_--_ _._-_-----__ _// SPREADER CLAMP
SOCKET HEAD _-°- _V///
SETSCREW _fa _ It- I WING NUT
7/8 IN. LONG --8 ""['_-_ "1_
HEX NUT t-_ LOCKWASHER
EXT. 1/4 IN.
BLADE SQUARE
WITH TABLE
/
2 MAKE SURE THE BLADE IS ALL THE WAY UP
AND SQUARE WITH THE TABLE.
3. Position SPREADER SUPPORT on rod until it is
even with the end of the rod.
\ SPREADER SUPPORT
EVEN WITH ROD
4. Assemble the 7/8 in. long setscrews, nuts,
Iockwashers and washers to the SPREADER
SUPPORT BRACKET and slip the nuts into the
slot in the spreader support.
5. Finger tighten ONLY THE HEX NUTS.
\',\ ; _
SQUARE NUT
• -____ L SETSCREW i
,-
/ ,.oc,,w,s.ER
17