Craftsman 113.221620 Owner's Manual page 23

3. Turn elevation handwheel clockwise to raise
motor shaft as high as it will go.
4. Insert shaft wrench over flat portions of motor
spacer and arbor wrench over arbor nut.
5. Hold shaft wrench and loosen arbor nut with
arbor wrench.
PULL TO LOOSEN/_
PUSH TO TIGHTEN
ARBOR
WR
/
/
ARBOR
WRENCH
/' / //!
TO INSTALL SAWBLADE
1, Install large inner blade collar onto motor shaft
with rounded surface toward motor.
2. Install saw blade onto shaft with top teeth
pointing toward front of saw.
3. Install small outer blade collar with flat surface
toward blade.
4. Install arbor nut. Note: Arbor nut should just be
snug. Do not overtighten.
IMPORTANT: Do not attempt to run saw without
both blade collars properly installed.
LARGE COLLAR
FLAT SURFACES (2" DIAMETER)
/
//-
jl_.J_ '_ 4- * SMALL COLLAR
/ _ _ (1-3_4" DIAMETER}
' HEX NU'f
j: ....
TOPTEETH POINTING _ _, <*'_-_:_
TO FRONT OF SAW t..
5. Install blade insert by placing keyhole slot in
insert over screw head in saw table and pushing
insert to rear of saw table engaging tab in insert
onto saw table ledge.
Tighten screw.
23