Craftsman 113.221620 Owner's Manual page 12

ADJUSTING 90 DEGREE BEVEL STOP
1. On the stop bracket are two 10-32 pan head
screws which set 90 ° stop position. If condition A
exists the two screws need to be turned clockwise
to obtain 90 ° setting. If condition B exists the
srews should be turned counterclockwise.
/
A
IBLADE
/
Ii
Ii
tl
LL
LI
[
I
II
It
!1
II
I/
/BLADE
B
2. Turn saw over.
3. Rotate bevel crank blade is in approximately 40 °
position and using phillips screwdriver rotate
screws slightly in direction necessary to correct
gap, (rotate screws equally). Recheck blade
position and readjust if necessary.
4. When 90 ° stop position is adjusted to your
satisfaction re-adjust pointer to 0° position.
BEVEL
STOP BRACKET I
BEVELSHAFT X J
BEVEL ADJUSTING
SCREWS
BEVEL
HANDWHEEL
1
J
ADJUSTING BEVEL POINTER
If blade IS SQUARE to table:
1. Check pointer.
If POINTER DOES NOT point to the"0" mark on the
bevel scale:
2. Remove Elevation Handwheel.
3. Loosen screw and adjust pointer . . . using
medium screwdriver.
4. Install Elevation Handwheel.
"----I
BEVEL
POINTER
/
/
/
/
/
t
\
12