Installing Rip Fence Guide Bars - Craftsman 113.24250 Owner's Manual

Lay REAR FENCE GUIDE BAR on table to act as a
straightedge. If outer edge of extension is higher or lower
than table surface;
A. Slightly loosen nuts holding bracket to extension
using 7/16 in. wrench.
B. Move end of extension up or down until outer edge
is even with table surface ... check with GUIDE
BAR ... tighten nuts.
C. Recheck INNER edge of extension to make sure it
has not moved ... readjust, if necessary,
\
\
mNSTALLING RiP FENCE GUIDE BARS
2,
3.
From among the loose parts find the following
hardware:
2 Hex. Head Screws, 5/16-18 x 1-1/2 in. long
2 Hex. Head Screws, 5/16-18x 1 in. long
4 Hex. Nuts, 5/16 18 (approx. dia. of hole 5/16 in.)
4 External Lockwashers, 5/16 in. (approx. dia. of hole
5/16 in.)
2 Spacers, 3/4 in. dia. x 1/2 in. long
2 Self-threading nuts
Lay guide bars on table.
NOTE: The various holes in the bars allow them to be
repositioned on the saw and also makes them adaptable
to other models.
Insert 1-1/2 in. long screw through the FIRST hole
from the LEFT IN THE FRONT BAR ... insert another
1-1/2 in. long screw through LARGE hole at
4.
EXTREME LEFT SIDE OF SWITCH BRACKET ther_
through SIXTH hole in bar. Hold them in place with a
piece of masking tape from the underside,
Place spacers on screws.
Insert bolts through holes in middle and on right side of
front of saw table ... install !ockwashers and nuts.
DON'T SCREW NUTS ON ALL THE WAY, just get
them started on the screws.
6o
7.
8.
Remove the 3 screws from rear of table extension.
Insert 1 in. long screws 'n FIRST and THIRD holes of
rear bar and attach to table the same way.
Insert ends of FENCE GUIDE BAR ROD through
round holes at outer end of bars.
NOTE: The ends of the ROD are not threaded ., . the
SELF THREADING NUTS will cut threads on the rod
as they are screwed on.
\
\