Craftsman 113.221620 Owner's Manual page 13

CHECKING 45 DEGREE BEVEL STOP
!. Turn elevation handwheel clockwise to raise
blade as high as it will go.
2. Turn bevel handwheel clockwise to tilt blade to
45 ° '
3. Lay head of combination square on the blade of
square as illustrated and place head against the
blade• Make sure square is not touching TIP of
one of the saw TEETH.
4. The 45 ° blade stop is set during manufacturing•
If adjustment is needed proceed to next step. If
bevel adjustment is satisfactory go on to installing
table extensions•
r
ADJUSTING 45 DEGREE BEVEL STOP
1. The 45 ° blade position is controlled by the
location of the sheet metal nut on end of bevel
shaft•
2. If condition A exists the sheet metal nut needs to
be turned clockwise (CW) to obtain 45 ° setting• If
condition B exists the nut should be turned
counterclockwise (CCW).
3. To correct condition A - Rotate bevel handle
CCW approximately 2 turns, place 11/16 inch
wrench on sheet metal nut and hold in place
while rotating handle counterclockwise in small
increments. Recheck blade position after each
rotation.
4. To correct condition B- Same procedure as No.
3, except, rotate handle clockwise while holding
nut.
5. Check blade clearance by rotating blade by hand
making sure blade does not strike insert or table•
SHEET METAL BEVEL LINK i
NUT _/ _ [_
WASHER BEVEL SHAFT
\
45 ANGLE
|LADE
A
\\
\',,.,
\\
\\
/\\
/ \\
/
45 ANGLE
\x
x\
N\
\\
\\\
INSTALLING TABLE EXTENSIONS
1. Among loose parts locate fourteen 1/4-20 x 5/8
inch long flat head hex socket screws.
2. Install right table extension and install seven
screws using a5/32 inch hex Lwrench. Just start
screws.
3. Install left table extension and install seven
screws using a5/32inch hex Lwrench. Just start
screws.
FLAT HEAD
HEX SOCKET
SCREWS
I
13