Craftsman 113.221620 Owner's Manual page 34

Sears Recommends the Following Accessories
ITEM CAT. NO.
Saw Blades ................................................ See Catalog
Molding Head Set ...................................... See Catalog
Dado Insert ....................................................... 9-22281
Molding Insert ................................................... 9-22282
Taper Jig .................................................... See Catalog
Dado Set .................................................... See Catalog
Steel Legs ......................................................... 9-22244
Sears may recommend other accessories not listed in
the manual.
See your nearest Sears store for other accessories.
Do not use any accessory unless you have received and
read complete instructions for use.
WARNING: Use only accessories recommended
for this saw. Using other accessories may be dan-
gerous.
TROUBLE SHOOTING
WARNING: TO AVOID INJURY FROM
ACCIDENTAL START, TURN SWITCH "OFF" AND
ALWAYS REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE TROUBLE SHOOTING.
TROUBLE SHOOTING -- GENERAL
TROUBLE
Excessive vibration.
Cannot make square cut
when crosscutting.
Cuts binds, burns or
stalls motor when
ripping.
Cut not true at 90 °
or 45 ° positions.
Tilt crank and elevating
crank turn hard.
Excessive blade wobble.
(Causes oversize kerf
and unsmooth cut)
1.
1.
Sharpen or replace blade.
1.
2.
PROBABLE CAUSE
Blade out of balance.
Miter gauge not adjusted
properly.
Dull blade with improper
tooth set.
Warped board.
3. Rip fence not parallel
to blade.
4. Spreader out of
alignment.
1. Stop nuts not properly
adjusted,
1. Sawdust on threads of tilt
screw or elevating screw.
1. Blade has excessive
wobble.
2. Blade collars not installed
properly.
1.
1.
1.
2.
3.
4.
REMEDY
Discard Blade and use a different blade.
See section "Miter Gauge."
Make sure concave or hollow side is facing
"down" feed slowly.
See "Assembly" section, "Aligning Rip Fence".
See "Assembly" section, "Installing
Blade Guard."
1. See "Assembly" section, "Blade Tilt, or
"Squareness of Blade to Table."
1. See "Maintenance and Lubrication" section.
1. Replace blade.
2. Make sure the large collar (2" Dia.)
is between motor and blade. (Installed
before blade).
34