List Of Loose Parts; Assembly; Installing Handwheels - Craftsman 113.221620 Owner's Manual

Model 113.221620 Table Saw with Table Extensions is
shipped complete in one carton.
Separate all parts from packing materials and check
each one with the illustration and the list of Loose
Parts to make certain all items are accounted for,
before discarding any packing material.
If any parts are missing, do not attempt to assemble
the table saw, plug in the power cord or turn the
switch on until the missing parts are obtained and
are installed correctly.
Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean, dry cloth.
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET
UNTIL ALL ASSEMBLY STEPS ARE COMPLETE,
AND YOU HAVE READ AND UNDERSTAND THE
SAFETY AND OPERATIONAL INSTRUCTIONS.
ITEM
A
B
C
D
E
F
G
H
K
L
LIST OF LOOSE PARTS
DESCRIPTION QTY.
Guard Assembly ..................... 1
Extension Table L.H .................. 1
Extension Table R.H .................. 1
Handwheel ......................... 2
Rip Fence Assembly ................. 1
Miter Gauge Assembly ................ 1
Owners Manual ..................... 1
Loose Parts Bag No. 507545
(Containing the following items):
Wrench ...................................................... 2
Bracket Spreader ....................................... 1
Clamp, Spreader ........................................ 1
N
O
P
Q
R
R
S
T
U
V
J
M
Loose Parts Bag No. 507546
(Containing the following items):
Washer, 17/64x9/16x3/64 .......................... 4
Screw, Pan Hd. 8-32x3/8 ........................... 2
Nut, Sq. 1/4-20 ........................................... 2
Screw, Soc. Set 1/4-20x7/8 ....................... 2
Lockwasher, Ext. 1/4 ................................. 4
Lockwasher, Ext. #8 .................................. 2
Nut, Hex 1/4-20 .......................................... 2
Screw, Truss Hd. 1/4-20x5/8 ..................... 2
Screw, Flat Hd. 1/4-20x5/8 ...................... 14
Key Switch ................................................. 1
Support Spreader ...................................... 1
Nut, Wing 1/4-20 ........................................ 2
A
o___@
N
ASSEMBLY
INSTALLING HANDWHEELS
1. From among the loose parts find two #8 external
Iockwashers and two 8-32 x 3/8 inch long Phillips
screws.
2. Install elevation handwheel onto elevation shaft
by lining up FLAT SPOT on shaft with flat inside
handwheel. Install screw and Iockwasher.
3. Install bevel handwheel onto bevel shaft by
lining up FLAT SPOT on shaft with flat inside
handwheel. Install screw and Iockwasher. SCREW
WARNING: Failure to complete the following two
steps could result in damage to your saw.
4. Turn elevation handwheel counter-clockwise to
pull motor away from inner packing cardboard.
5. Remove cardboard.
REMOVE CARDBOARD FROM
UNDERNEATH MOTOR
LOCKWASHER
/
SCREW