Lighting The Gco4C/Gco6C Oven; Before First Use - Vulcan-Hart GCO4C ML-52357 Installation & Operation Manual

ON/OFF/OVEN COOL SWITCH
2-SPEED FAN SWITCH
LIGHT SWITCH
GAS VALVE

LIGHTING THE GCO4C/GCO6C OVEN

1. Turn manual Gas Valve ON.
2. Push On/Off/Oven Cool switch to the ON position and set Thermostat to its maximum setting. The Heat light
should come on. If Heat light is not on, make sure door is closed.
3. If the oven fails to light, push On/Off/Oven Cool switch to the OFF position. Wait 5 minutes before retrial.

BEFORE FIRST USE

Before using the oven for the first time, it must be "burned in" to release any odors that might result from heating
the new surfaces in the chamber.
1. Using a clean damp cloth, wipe the inside of the oven, including the racks.
2. Close the oven doors, push the On/Off/Oven Cool switch to the ON position, turn the Thermostat to
300 F (149 C) and allow the oven to cycle for 6 to 8 hours before turning the On/Off/Oven Cool switch OFF.
1. ON turns oven control circuits on.
2. OFF turns oven control circuits off.
3. OVEN COOL allows the fan motor to run with the doors ajar to speed oven
cooling.
Adjusts air velocity in the oven.
Turns lights in the oven on or off.
When ON, allows gas to flow to the ignition system.
– 16 –