Lighting The Sg4D And Sg6D Ovens; Using The Sg4D And Sg6D Ovens - Vulcan-Hart SG4C ML-114876 Installation & Operation Manual

LIGHTING THE SG4D AND SG6D OVENS

1. Turn the main gas supply ON.
2. Turn the gas control valve (located behind the small door on the lower front panel) ON.
3. Push the Master Switch ON and turn Thermostat to its maximum setting. Both the ON and HEAT
lights should come on. If HEAT light is not on, make sure the oven door(s) are closed.
4. If the oven fails to light, the red No Ignition light will be lit and remain on. Push the Master Switch
OFF. Turn gas off.
5. Wait 5 minutes before repeating Steps 1 through 4.
If the oven does not light after three trials, turn off the main gas valve and call a qualified servicer.

USING THE SG4D AND SG6D OVENS

Preheating
1. Select the proper rack arrangement for the product to be cooked. Refer to RACK ARRANGEMENTS,
page 19.
2. Make sure the doors are closed.
3. Push the Master Switch ON. The amber ON light will come on, indicating that power to the oven
is on.
4. Set the Power Level Control as desired. A power level control setting of 10 is recommended for
preheating.
5. Set the two-speed Fan Switch to the desired setting.
6. Set the Thermostat as desired. The Heat light will come on and remain on until the oven reaches
the set temperature (approximately 10 to 15 minutes for settings from 300 F
Refer to SUGGESTED COOKING GUIDELINES for temperatures and times for various products.
7. Prepare product and place in suitable pans. When the white Heat light goes off, the oven has
reached the desired preheat temperature.
Cooking
1. Open doors and load the product into the oven. Place pans in the center of the racks. Close the
doors.
2. Set the Timer. After the preset time lapses, turn timer OFF to stop buzzer.
3. When product is done, open doors and carefully remove cooked product from the oven. Wipe up
any spills.
End of Day
1. Turn the Thermostat and Power Level Controls OFF.
2. Push Master Switch to OVEN COOL. Leave door ajar while the fan is on to cool the oven.
3. When oven has cooled sufficiently, push Master Switch OFF.
4. Turn gas valve (located behind panel) OFF and clean oven.
Extended Shutdown
Repeat Steps 1 through 4 above. Unplug oven and shut off manual gas valve.
– 10 –
to 400 F
(149 C) (204 C)
.