Oven Doors And Bearings (Independent Doors) - Vulcan-Hart ML-126743 Service Manual

VC4E & VC6E Series Full Size Electric Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
Fig. 19
2. Independent doors:
A. Remove the door handle then remove the
outer door panel.
B. Lift out the inner door panel and window
assembly.
NOTE: Left door only - remove door seal from the
inside edge of the door.
3. Simultaneous doors:
A. If replacing window on the left door, remove
the handle from the front of the door then
remove door seal from the inside edge of the
door.
1) Lift out the inner door panel and
window assembly.
2) If replacing window on the right door,
remove the screws along the inside
edge (if applicable) of the door then
remove the inner door panel and
window assembly.
4. Remove the screws securing the window "tabs"
to the door bracket and lift the window assembly
out from the door frame.
F25105 Rev. B (0217)
5. Reverse procedure to install the replacement
window.
OVEN DOORS AND BEARINGS
(INDEPENDENT DOORS)
1. Remove the top front cover and bottom front
cover as outlined under COVERS AND
PANELS.
2. Remove the door switch lever.
Page 14 of 64
Fig. 20
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
There may be multiple circuits. Be sure
all circuits are disconnected.