Oven Doors And Bearings - Vulcan-Hart SG4D ML-114875 Service Manual

FRONT VIEW OF MOTOR
FROM INSIDE OVEN CAVITY
MOTOR ROTATES CLOCKWISE
12. Slide blower onto motor shaft until hub is
flush with end of shaft, then tighten setscrews.
13. Adjust motor position until blower is parallel
to motor mounting plate as outlined in Blower
Adjustment under Service Procedures and
Adjustments.
14. Position motor mounting plate on the rear
wall and secure with nuts and washers.
15. Replace the baffle panel and snorkel.
16. Replace the air baffle on the rear wall at the
lower right hand corner.
17. Remove cardboard from the bottom of the
oven cavity.
18. Install racks.
19. Check oven for proper operation.
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
PL-56051
– 15 –

OVEN DOORS AND BEARINGS

1. Remove the top front cover and bottom front
cover as outlined under Covers and Panels.
2. Remove the door switch lever.
3. Remove the lower door seal strip to expose
the mounting screws of the door assembly.
4. Remove the two lower sill bolts by the lower
door shaft and the four countersunk screws
from the lower sill.
A. The door assembly is heavy and will drop
down once the last screw is removed. If
removing the door assembly without
assistance, the ignition cable, flame
sense lead and gas manifold should also
be removed to avoid damage to these
components.
5. Tilt the top of the door slightly forward and lift
the door up until the bottom of the door shaft
clears the opening in the sill.
6. Lay the door flat to prevent damage.