Installation; Unpacking - Vulcan-Hart EV12 Series Installation & Operation Manual

UNPACKING

This range was inspected before leaving the factory. The transportation company assumes full responsibility for
safe delivery upon acceptance of the shipment. Immediately after unpacking, check for possible shipping
damage. If the range is found to be damaged, save the packaging material and contact the carrier within 15 days
of delivery.
Remove all shipping wire, wood blocking, and accessories. Uncrate the high shelf, back guards and/or broiler.
Before installing, verify that the electrical service agrees with the specifications on the rating plate located
behind the kick panel on the left side. If the supply and equipment requirements do not agree, contact your
dealer or Vulcan-Hart immediately.
If it is required to remove the door and install it for access through a kitchen door, follow the instructions below.
Door removal
1. Open door.
2. Grasp door firmly at both sides.
3. Lift door upward and pull it out so bottom hinge tab disengages.
* This may be easier to accomplish one side at a time.
4. Close door almost shut and lower slightly to disengage top hinge tab.
5. Pull door outward.
Door installation
1. Grasp door firmly at both sides.
2. Starting with either LH or RH side top hinge tab, angle door and slide top hinge tab into opening between
hinge stop roller and hinge stop pin.
3. Lift door up (compress door hinge as if opening the door) and position bottom tab downward about 30
degrees down from horizontal.
4. Push door inward, inserting downward angled bottom hinge tab into opening just above hinge stop pin.
* Bottom hinge tab must enter chassis at downward angle to engage.
5. Bottom hinge tab should engage on hinge stop pin.
6. Open door and pull door outward until bottom hinge tab locks on hinge stop pin.
7. Repeat above steps for opposite side.
8. Open and close door to make sure door hinges are locked in place and door operates smoothly.

INSTALLATION

5 F-38251 (08-09) REV D