Installation - Vulcan-Hart HDR V series Operation Manual

PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE
Heavy duty sectional ranges are produced with quality workmanship and material. Proper installation, usage
and maintenance of your range will result in many years of satisfactory performance.
The manufacturer suggests that you thoroughly read this entire manual and carefully follow all of the
instructions provided.
UNPACKING
This range was inspected before leaving the factory. The transportation company assumes full responsibility
for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for possible shipping damage
If the range is found to be damaged, save the packaging material and contact the carrier withing 15 days of delivery.
Carefully unpack range(s) and place in the approximate installation position, whether as a battery or single stand-
alone range.
Remove parts (packed in a cardboard box) from oven cavity, or cabinet body, or on top of modular range(s).
Remove wire or nut from rear of each burner before installing the range.
Before installing, check the electrical service (Convection Oven Models only) and type of gas supply
(natural or propane) to make sure they agree with the speci cations on the rating plate located on the
inside of the burner box lower panel. The rating plate will show the voltage, phase, cycle, full load
ampere, BTU, as well as the type of gas. If the supply and equipment requirements do not agree, do
not proceed with the installation. Contact your dealer or manufacturer.
LOCATION
The equipment area must be kept free and clear of combustible substances.
INSTALLATION CLEARENCES
Open Tops: 6" at rear to combustible construction and 0" to non-combustible.
10" at sides to combustible construction and 0" at sides for non-combustible constructions.
Hot Tops / Manual Griddles: 6" at rear to combustible construction and 0" to non-combustible.
4" at sides to combustible construction and 0" to sides for non-combustible constructions.
Thermo-Controlled Griddle / French Plate: 6" at rear to combustible construction and 0" to
non-combustible. 2" at sides to combustible construction and 0" to sides for non-combustible constructions.
Work Top: 0" at sides and rear to combustible and non-combustible construction.
Ovens: Standard Oven - 3" at sides and rear for combustible and 0" to non-combustible construction.
Convection Oven - 1" at sides and rear for combustible and 0" to non-combustible construction.
Installation, Operation and Care Of
HEAVY DUTY SECTIONAL GAS RANGES

INSTALLATION

GENERAL
— 4 —